View Single Post
Old 02-27-2008, 02:43 PM   #7
Arika
heart
 
Arika's Avatar
 
Status: Offline
Join Date: May 2007
Gender :female
Location: under your bed's blanket
Age: 21
Posts: 13,125
Arika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud ofArika has much to be proud of
Awards Showcase
Referral Award Doujinshi-Archive Award 
Total Awards: 2
Re: Playing psp games?

Quote:
Originally Posted by ssgoku2425 View Post
I just needed help on how to play the psp games. i just have got one. do i need an emulator or can the files be copied to the psp? any help would be appreciated.
You can downgrade it
I can't explain what i did because i don't have time to write a lot but this will help you downgrade it

Buy this battery --> Max tool battery which is equal to the pandora battery. This won't brick your psp and it will downgrade it easily , just put the battery once you buy it, create your magic memory card, read more about it, then that is it, follow these youtube to help you downgrade it then upgrade it to custom firmware ;p

Battery

http://us.codejunkies.com/Products/P..._EF000536.aspx

Memory card

http://www.buy.com/prod/sandisk-4gb-...202636843.html

Then you need to buy the cord that connect your psp to your pc then download and read these sites, oh and you need a memory card pro due. You can buy it online cheap from here

read about this:

I think this will help you make the magic memory card i think, don't modify your battery to turn it Pandora, just buy that max tool battery it is easier that way so skip these step about the battery part.

Quote:
Search Google for the TOTALNewbi MS Installer. This will create the files you need for the memory stick. It's much more versatile then the files I have previously been distributing.

Ok, so you want to unbrick or downgrade your PSP but don't have a PSP capable of running homebrew apps. No problem! In this tutorial I will show you how to modify the battery's hardware to make it activate service mode.

This is our victim. Please note that while this concept may work on non-Sony batteries, only official batteries are guaranteed to have the same internals, so we recommend using one.

STEP 1:

The first thing you need to do is obviously crack open the battery. Surprisingly, the battery isn't very hard to get in to. In this picture you can see that I'm just using a guitar pick to slide in through an edge and slide around the perimeter of the battery to seperate the two halves.

STEP 2:

Next, we need to locate a certain chip. The chip has the model number S93C56 printed on it. We are going to need to desolder pin 5 and lift it off of the board. Here is a magnified view of the board, which shows where the chip is and which pin needs to be lifted.

Newer batteries have a much smaller board with a different layout. The same chip needs to have the pin lifted, but the chip is in a different position. Once you've located chip S93C56, the rest of the instructions are basically the same. This has been confirmed with the 2200 mAH Official Sony battery.

STEP 3:

If you are not confident in your soldering skills, have a less than steady hand or have a larger-than-optimal sized tip, please desolder the cell pack from the battery first. If you make contact between pins 5 and 6 then you will short ground to +3.6VDC! Not good! When desoldering the cell, only keep the iron on long enough to melt the solder. If you can, use a higher wattage iron so that the tip will be hotter, but you won't transfer as much heat to the cell pack. Remember that heat + Li-Ion battery = large explosion (t3h sux0r5, unless you get in on video. Seriously though, this operation is not for the faint hearted, and should definitely not be your first soldering experience. I recommend trying your hand on lifting the pins on an N64 CPU chip. Surely if you spend enough time here you have a couple killed N64 mobos laying around. )

Now is actually desoldering the pin. There are a few ways you could do this, but I think my method is the best because its less likely to damage components near by. Use an Xacto knife with a sharp tip and try to put it underneath the pin. Get somebody to hold a soldering iron (WITH A VERY FINE CONICAL TIP!) on the pin. When the solder melts you can pop the pin up with the knife. Be sure not to hold the iron on the board too long to avoid the lithium battery from getting too hot and exploding. When your done it will look something like this.

STEP 4:

Finally, close the battery's casing. Use some Krazy Glue to keep it closed, or just use electrical tape around the edges like I did. I don't actually recommend the electrical tape as it makes the battery very snug in the compartment and it takes a bit of force to get it out. You can use the battery just like a regular Pandora's battery. As for getting the Memory Stick files, I can tell you that they are out there and you can find them after a bit of Googling. However, I can't tell you exactly where to find them as they contain copyrighted Sony code, and sharing them is illegal.

How does this work?

The pin that we just lifted was actually the ground pin of the EEPROM. Removing this pin effectively shuts off the EEPROM. When the microcontroller inside the battery tries to read the EEPROM, it will think the EEPROM contains all 1s (in binary). This is because of the pull-up resistors on the data lines. So the microcontroller returns a serial number of 0xFFFFFFFF to the PSP, which then goes into service mode.

Thank you for reading this, and if you have any questions, make sure to post and I'll try to help you!

-iam
http://dl.qj.net/TOTALNewbi-easyInstaller-PSP-Tools-Utilities-%28on-PC%29/pg/12/fid/14749/catid/193

and read about this to upgrade your psp from 1.5 to custom firmware.

PSP Upgrader/Downgrader is an easy to use program to make upgrading, downgrading, and installing a custom firmware very easy.
Created by Bob Joe (me )

Download:
Full: http://www.gigasize.com/get.php/-109...rader_Full.exe (1.10)
Lite: http://blacktooth.googlepages.com/PS...graderLite.exe (1.11)

The lite version doesn't have any official sony updates, but it can download them automatically.

Changelog:
1.11
Added 3.40 LE-3
Added automatically check for updates in options

1.10
Added a status bar
Added ability to download missing files
Added Tools>Download Firmwares
Added 3.40 LE
Fixed the options window glitch
Added free space checking
Added warning message if Memory Stick is bigger than 4 gb.
Give Feedback Via Comments

---------------
then upgrade

http://www.youtube.com/watch?v=kBs8-fQJwtw

http://www.youtube.com/watch?v=rJHq1orzLTI

Find youtube that helps you downgrade the psp

Arika & Christie
  Reply With Quote